NSF Product and Service Listings

These NSF Official Listings are current as of Monday, September 01, 2014 at 12:15 a.m. Eastern Time. Please contact NSF International to confirm the status of any Listing, report errors, or make suggestions.

Alert: NSF is concerned about fraudulent downloading and manipulation of website text. Always confirm this information by clicking on the below link for the most accurate information: http://info.nsf.org/Certified/Plumbing/Listings.asp?Company=C0094705&Standard=0MP&


MP
Mechanical Plumbing Products



CuraFlo IP LLC 
4035 East Oasis Street
Mesa, AZ 85215 
United States 
800-714-9259 
Visit this company's website

Facility : # 1 USA

Product Type   Material Type   Trade Name   Product Standard

Coating[1] [2]
 
Epoxy
 
CuraPoxy LS
 
ASTM F2831

[1] Certified for Immediate Return to Service.
[2] Number of Coats: 1-2
    Maximum Field Use Dry Film Thickness (in mils): 40
    Maximum Thinner: None
    Recoat Cure Time and Temperature: None
    Final Cure Time and Temperature: 1 hour at 100°F followed by 4 hours at 72°F
    Special Comments: Heat Part A and Part B to 100°F before mixing. Mix ratio of Part A:B
    is 3:1 by volume. A 15-minute flush at 2.5-3.5 gpm at the highest possible service
    temperature (73°F for cold water, 140°F for domestic hot water, or 180°F for commercial
    hot water) is required before placing the pipe back in service.


Number of matching Manufacturers is 1
Number of matching Products is 1
Processing time was 0 seconds