NSF Product and Service Listings

These NSF Official Listings are current as of Saturday, December 21, 2024 at 12:15 a.m. Eastern Time. Please contact NSF to confirm the status of any Listing, report errors, or make suggestions.

Alert: NSF is concerned about fraudulent downloading and manipulation of website text. Always confirm this information by clicking on the below link for the most accurate information: http://info.nsf.org/Certified/Plumbing/Listings.asp?TradeName=Pexidan&

Did you know?

The new NSF Product Listings website is available for NSF/ANSI 14-Certified products with a new look and feel. Click on "Try it Now" to check it out!
NSF/ANSI 14
Plastics Piping System Components and Related Materials

Click here for a list of End Use Code Designations.

Click on Product Standards or footnote in blue to view the referenced document


 
SACO AEI Polymers, Inc. 
3220 Crocker Avenue
Sheboygan, WI 53081 
United States 
920-803-0778
Visit this company's website

Facility : Sheboygan, WI

Potable Water - Materials

Material Type End Use Trade Name Product Standard
PEX 5006$ * +++ 1 Pexidan® L/T (Natural) N/A
PEX 5106$ * +++ 1 Pexidan L/T (Red, White, and Blue) N/A
PEX 5306$ * +++ 1 Pexidan® L/T Eclipse™ Black N/A
PEX 5306# $ ^ 1 Pexidan® L/T Eclipse™ (Red, White, and Blue) N/A
PEX 5206$ * +++ 1 Pexidan® L/T-UV N/A
PEX 5306$ * +++ 1 Pexidan® L/T-UV (Blue) N/A
PEX 5206$ * +++ 1 Pexidan® L/T-UV (Red and White) N/A
PEX 5306$ * +++ 1 Pexidan® L/T-UV (Red and White) N/A 

# Potable water tubing made with Pexidan® L/T Eclipse (Blue, Red, and White) consists of
  two-layered coextruded tube, having a black inner layer and a colored, outer skin layer.
   Pexidan® L/T Eclipse (Blue, Red, and White) is not a certified material for solid wall
  tubing or as a water contact material.
$ Meets the chlorine resistance requirements of ASTM F876 when tested in accordance with
  ASTM F2023.
* Tubing manufactured using this material is cure process dependent.  Use of this material
  in NSF Certified tubing requires NSF's prior authorization and transfer of the PPI
  hydrostatic design basis from the Plastics Pipe Institute (PPI).  Tubing produced from
  this material was tested to the health effects requirements of NSF/ANSI/CAN 61, the
  performance requirements of ASTM F876/F877, and the performance requirements of CSA
  B137.5.  This material has been qualified for use in tubing at 1/4" and greater
  diameters.
^ Tubing manufactured using this material is cure process dependent.  Use of this material
  in NSF Certified tubing requires NSF's prior authorization.  Coextruded tubing produced
  using this material as the outer skin layer was tested to the performance requirements
  as ASTM F876/F877.  This material has been qualified for use in tubing at 1/4" and
  greater diameters.
+++ Material complies with NSF/ANSI/CAN 61 health effects requirements when tested at
    temperatures up to and including Commercial Hot (180° F).

Number of matching Manufacturers is 1
Number of matching Products is 8
Processing time was 0 seconds