NSF Product and Service Listings
These NSF Official Listings are current as of Monday, July 22, 2024 at 12:15 a.m. Eastern Time. Please contact NSF to confirm the status of any Listing, report errors, or make suggestions.
Alert: NSF is concerned about fraudulent downloading and manipulation of website text. Always confirm this information by clicking on the below link for the most accurate information: http://info.nsf.org/Certified/PwsComponents/Listings.asp?Company=38570&Standard=061&
NSF/ANSI/CAN 61
Drinking Water System Components - Health Effects
Drinking Water System Components - Health Effects
NOTE: Unless otherwise indicated for Materials, Certification is only for the Water Contact Material shown in the Listing. Click here for a list of Abbreviations used in these Listings. Click here for the definitions of Water Contact Temperatures denoted in these Listings. Products certified to NSF/ANSI/CAN 61 comply with the health effects criteria in NSF/ANSI/CAN 600.
| RectorSeal LLC |  |
| 2601 Spenwick Drive | |
| Houston, TX 77055 | |
| United States | |
| 713-263-8001 | |
| Visit this company's website |
Facility : # 1 USA
Joining and Sealing Materials
| Water | Water | |||
| Contact | Contact | |||
| Trade Designation | Size | Temp | Material | |
|
Fluxes |
||||
| NOKORODE® Aqua-Flux™[G] | >= 1/2" | C. HOT | FLX | |
| NOKORODE® Regular Paste Flux[G] | >= 1/2" | C. HOT | FLX | |
[G] Product is Certified to NSF/ANSI 372 and conforms with the lead content requirements for
“lead free” plumbing as defined by California, Vermont, Maryland, and Louisiana state
laws and the U.S. Safe Drinking Water Act.
|
||||
|
Solvent Cements |
||||
| Sam™ CL-3[2] [G] | >= 1/2" | C. HOT | CLE | |
| Sam™ CL-3L - Low VOC[2] [G] | >= 1/2" | C. HOT | CLE | |
[2] This product is a cleaner that is intended to be used directly before application of a
solvent cement. An additional primer is not required.
[G] Product is Certified to NSF/ANSI 372 and conforms with the lead content requirements for
“lead free” plumbing as defined by California, Vermont, Maryland, and Louisiana state
laws and the U.S. Safe Drinking Water Act.
|
||||
|
Thread Compounds |
||||
| Blue+™[G] | >= 1/2" | C. HOT | TC | |
| No. 100 Virgin™[1] [G] | >= 1/2" | C. HOT | TC | |
| Pure White Teflon Pipe Compound[1] [3] [G] | >= 1/2" | C. HOT | TC | |
| RectorSeal® No. 5®[1] [G] | >= 1/2" | CLD 23 | TC | |
| RectorSeal® T Plus 2®[1] [G] | >= 1/2" | C. HOT | TC | |
| Tru-Blu™[1] [G] | >= 1/2" | CLD 23 | TC | |
[1] Products were prepared for evaluation according to manufacturer's instructions.
[3] DuPont Registered Trademark.
[G] Product is Certified to NSF/ANSI 372 and conforms with the lead content requirements for
“lead free” plumbing as defined by California, Vermont, Maryland, and Louisiana state
laws and the U.S. Safe Drinking Water Act.
|
||||
Facility : # 2 USA
Joining and Sealing Materials
| Water | Water | |||
| Contact | Contact | |||
| Trade Designation | Size | Temp | Material | |
|
Patching Materials [G] |
||||
| RectorSeal EP200 Epoxy Putty | [1] [2] | C. HOT | EPOXY | |
| RectorSeal EP400 Epoxy Putty | [1] [2] | C. HOT | EPOXY | |
[1] Certified for a maximum surface area to volume ratio of 0.3 sq. in./L in pipe or 1% of a
20,000 gallon tank.
[2] To obtain the proper mix, use at least a 3/4" length, but no more than 1/3 of a full
stick, of product which has been cut with a knife. Product must be mixed for 60-90
seconds.
[G] Product is Certified to NSF/ANSI 372 and conforms with the lead content requirements for
“lead free” plumbing as defined by California, Vermont, Maryland, and Louisiana state
laws and the U.S. Safe Drinking Water Act.
|
||||
Number of matching Manufacturers is 1
Number of matching Products is 12
Processing time was 0 seconds
