NSF Product and Service Listings

These NSF Official Listings are current as of Monday, July 22, 2024 at 12:15 a.m. Eastern Time. Please contact NSF to confirm the status of any Listing, report errors, or make suggestions.

Alert: NSF is concerned about fraudulent downloading and manipulation of website text. Always confirm this information by clicking on the below link for the most accurate information: http://info.nsf.org/Certified/PwsComponents/Listings.asp?Company=C0000064&Standard=061&


NSF/ANSI/CAN 61
Drinking Water System Components - Health Effects

NOTE: Unless otherwise indicated for Materials, Certification is only for the Water Contact Material shown in the Listing. Click here for a list of Abbreviations used in these Listings. Click here for the definitions of Water Contact Temperatures denoted in these Listings. Products certified to NSF/ANSI/CAN 61 comply with the health effects criteria in NSF/ANSI/CAN 600.

 
Interplastic Corporation 
1225 Willow Lake Boulevard
St. Paul, MN 55110 
United States 
800-736-5497 
651-481-6860
Visit this company's website


Facility : Pryor, OK

Protective (Barrier) Materials

    Water Water
  Water Contact Contact Contact
Trade Designation Size Restriction Temp Material

Resin
CORVE8300DW[1] [2] CLD 23 VE 

[1] Number of Coats: 1
    Maximum Field Use Dry Film Thickness (in mils): 10 
    Recoat Cure Time and Temperature: 2-100 hours at 65°F
    Final Cure Time and Temperature: 4 hours at 160°F followed by 2 hours at 180°F
    Special Comments: Please refer to the Interplastic Product Bulletin for system
    requirements.  Cure time: 1-100 hours at ambient temperatures 65-90°F.  Post-cure: 4
    hours at 160°F and then at least 2 hours at 180°F. Finishing: Equipment must be washed
    with a non-ionic detergent solution and rinsed with potable water prior to use.
[2] Certified for use as the resin in coating systems used on pipes >=1/2" and tanks >=150
    gallons.

Number of matching Manufacturers is 1
Number of matching Products is 1
Processing time was 0 seconds