NSF Product and Service Listings

These NSF Official Listings are current as of Wednesday, April 23, 2014 at 12:15 a.m. Eastern Time. Please contact NSF International to confirm the status of any Listing, report errors, or make suggestions.

Alert: NSF is concerned about fraudulent downloading and manipulation of website text. Always confirm this information by clicking on the below link for the most accurate information: http://info.nsf.org/Certified/PwsComponents/Listings.asp?Company=C0035779&Standard=061&



NSF/ANSI 61
Drinking Water System Components - Health Effects

NOTE: Unless otherwise indicated for Materials, Certification is only for the Water Contact Material shown in the Listing. Click here for a list of Abbreviations used in these Listings.


 
Merit Brass Company 
One Merit Drive
Cleveland, OH 44143 
United States 
800-726-9800 
216-261-9800
Visit this company's website

Facility : Cleveland, OH

Pipes and Related Products

    Water Water
    Contact Contact
Trade Designation Size Temp Material

Pipe
Merit Brass Pipe Nipples[1] [G] 1/8" - 2" CLD 23 BRASS

[1] Certified to the maximum length per residence listed under size. Pipe nipples are
    available in various lengths up to 72". However, the total length used within a single
    residence is restricted to lengths listed below. When multiple sizes are used in
    combination, the most restrictive length restriction applies. When used in the
    distribution system as a component of a mechanical device, no restriction applies.
    
    Size    Length 
    1/8"    17.7 ft
    1/4"    12.3 ft
    3/8"    8.6 ft
    1/2"    6.7 ft
    3/4"    4.9 ft
    1"      3.8 ft
    1 1/4"  2.8 ft
    1 1/2"  2.4 ft
    2"      no restriction
    
    Nipples may have external tapered threaded ends, external straight threaded ends, roller
    cut ends, ream and chamfered ends, square cut ends, or grooved ends. Threads may be
    NPSM, NPSL, NPSH, NPTF or BSPT.
    
    This product is Certified by NSF to NSF/ANSI 61 for use in drinking water supplies of pH
    6.5 and above.  Drinking water supplies that are less than pH 6.5 may require corrosion
    control to limit leaching of copper into the drinking water.
[G] Product is Certified to NSF/ANSI 372 and conforms with the lead content requirements for
    “lead free” plumbing as defined by California, Vermont, Maryland, and Louisiana state
    laws and the U.S. Safe Drinking Water Act.

    


Number of matching Manufacturers is 1
Number of matching Products is 1
Processing time was 0 seconds