NSF Product and Service Listings
These NSF Official Listings are current as of Monday, July 22, 2024 at 12:15 a.m. Eastern Time. Please contact NSF to confirm the status of any Listing, report errors, or make suggestions.
Alert: NSF is concerned about fraudulent downloading and manipulation of website text. Always confirm this information by clicking on the below link for the most accurate information: http://info.nsf.org/Certified/PwsComponents/Listings.asp?Company=C0205182&Standard=061&
NSF/ANSI/CAN 61
Drinking Water System Components - Health Effects
Drinking Water System Components - Health Effects
NOTE: Unless otherwise indicated for Materials, Certification is only for the Water Contact Material shown in the Listing. Click here for a list of Abbreviations used in these Listings. Click here for the definitions of Water Contact Temperatures denoted in these Listings. Products certified to NSF/ANSI/CAN 61 comply with the health effects criteria in NSF/ANSI/CAN 600.
Mitsubishi Chemical Corporation | |
1-1 Marunouchi 1-chome | |
Chiyoda-ku, Tokyo 100-8251 | |
Japan | |
81 3 6748 7467 | |
Visit this company's website |
Facility : Dalian, China
Mechanical Devices
Water | Water | |||
Contact | Contact | |||
Trade Designation | Size | Temp | Material | |
Ultrafiltration Devices[1] [2] [3] |
||||
STERAPORE 78E0024SA | [4] | CLD 23 | MLTPL | |
STERAPORE 78E0040SA | [4] | CLD 23 | MLTPL | |
[1] Certification requested for a minimum flow rate of 9,000 liters per element per day. [2] This product requires the following flush prior to being placed into service: 1. Fill membrane tank with running water and wash the element surface with air for 10 minutes. 2. Completely drain the membrane tank of water. 3. Fill the membrane tank with running water again and start up the filtration pump (repeat sequence of about 1 minute of filtration and 1 minute of backwash, 5 times total). 4. Completely drain the membrane tank of water. 5. Fill the membrane tank with running water and filtrate at a constant flow rate. 6. Perform air scrubbing and backwash after a certain time elapses after starting filtration. 7. The cleaning procedure shall be complete after filtration for 360 minutes in total. - Estimated amount of cleaning water: 100 L/m2 x number of treatment - If element is not used soon afterward, start normal operation after filtering raw water again for 3 hours and discharging filtered water. - Treat filtered water as waste fluid until completion of cleaning. [3] Only products bearing the NSF Mark on the product, product packaging, and/or documentation shipped with the product are Certified. [4] Certified for the following sizes: 1250 mm x 1300 mm x 30 mm 1250 mm x 2000 mm x 30 mm |
Number of matching Manufacturers is 1
Number of matching Products is 2
Processing time was 0 seconds