NSF Product and Service Listings

These NSF Official Listings are current as of Monday, August 17, 2026 at 12:15 a.m. Eastern Time. Please contact NSF to confirm the status of any Listing, report errors, or make suggestions.

Alert: NSF is concerned about fraudulent downloading and manipulation of website text. Always confirm this information by clicking on the below link for the most accurate information: http://info.nsf.org/Certified/PwsComponents/Listings.asp?Company=C0214614&Standard=061&


NSF/ANSI/CAN 61
Drinking Water System Components - Health Effects

NOTE: Unless otherwise indicated for Materials, Certification is only for the Water Contact Material shown in the Listing. Click here for a list of Abbreviations used in these Listings. Click here for the definitions of Water Contact Temperatures denoted in these Listings. Products certified to NSF/ANSI/CAN 61 comply with the health effects criteria in NSF/ANSI/CAN 600.

 
United Felts Inc. 
450 College Drive
Martinsville, VA 24112 
United States 
888-485-2477 
319-239-9910
Visit this company's website


Facility : Sandy, UT

Joining and Sealing Materials

    Water Water
    Contact Contact
Trade Designation Size Temp Material

Adhesive
United Blue Adhesive[1] [2] CLD 23 EPOXY 

[1] Product is a two part adhesive mixed at a ratio of 2 part A to 1 part B by volume.					
    Adhesive cure time is 60 minutes at 70F					
    Following cure, product must be flushed with ambient temperature tap water for 1 hour. 
[2] Certified for use in immediate return to service pipe liner 4" and greater at a surface
    area to volume ratio of 0.08 in2/L.


Protective (Barrier) Materials

    Water Water
  Water Contact Contact Contact
Trade Designation Size Restriction Temp Material

Pipe Liner - Immediate Return to Service
CIPP Corp H2O[1] >= 4" CLD 23 MLTPL
CIPP Corp H2O[2] >= 4" CLD 23 MLTPL
UnitedBlue[1] [2] >= 4" CLD 23 MLTPL 

[1] Final cure time and temperature: Resin is mixed and applied to felt side of liner, then
    cured by steam.  Steam cure is a minimum of 2 hours at a range between 65°C and 109.7°C.
     After the cure, lined pipes must be subject to a minimum ambient cure of 96 hours.
    
    Special Comments: Mix ratio of resin (Part A:Part B) is 100:45 by weight +/- 2.5%.
[2] Final cure time and temperature: Resin is mixed and applied to felt side of liner, then
    cured by hot water.  Hot water cure is a minimum of 2 hours at a range between 67°C and
    90°C.  After the cure, lined pipes must be subject to a minimum ambient cure of 96
    hours.
    
    Special Comments: Mix ratio of resin (Part A:Part B) is 100:45 by weight +/- 2.5%.

Number of matching Manufacturers is 1
Number of matching Products is 4
Processing time was 0 seconds