NSF Product and Service Listings

These NSF Official Listings are current as of Monday, July 22, 2024 at 12:15 a.m. Eastern Time. Please contact NSF to confirm the status of any Listing, report errors, or make suggestions.

Alert: NSF is concerned about fraudulent downloading and manipulation of website text. Always confirm this information by clicking on the below link for the most accurate information: http://info.nsf.org/Certified/PwsComponents/Listings.asp?Company=C0734282&Standard=061&


NSF/ANSI/CAN 61
Drinking Water System Components - Health Effects

NOTE: Unless otherwise indicated for Materials, Certification is only for the Water Contact Material shown in the Listing. Click here for a list of Abbreviations used in these Listings. Click here for the definitions of Water Contact Temperatures denoted in these Listings. Products certified to NSF/ANSI/CAN 61 comply with the health effects criteria in NSF/ANSI/CAN 600.

 
TIPCO Technologies, Inc. 
11412 Cronhill Drive
Owings Mills, MD 21117 
United States 
410-356-0003
Visit this company's website


Facility : Glen Burnie, MD

Joining and Sealing Materials

    Water Water
    Contact Contact
Trade Designation Size Temp Material

Gasket/Sealing Materials
American Biltrite EPDM[1] [G] [2] C. HOT EPDM
Garlock Multi-swell 3760[G] [3] CLD 23 OTHER
Teadit NA1082SAN [4] CLD 23 NBR 

[1] This product has also been evaluated for use in Mechanical Plumbing Device applications
    with a maximum use restriction of 0.2 square inches/L.
[2] Certified for a maximum surface area to volume ratio of 2.0 square inches/L.
[3] Certified for a maximum width of 1/8” when used with pipes 1'' - 144'' in diameter.
[4] Certified for a maximum surface area to volume ratio of 1.1 square inches/L.
[G] Product is Certified to NSF/ANSI 372 and conforms with the lead content requirements for
    “lead free” plumbing as defined by California, Vermont, Maryland, and Louisiana state
    laws and the U.S. Safe Drinking Water Act.

O-Rings
American Biltrite EPDM[1] [G] [2] C. HOT EPDM
Teadit NA1082SAN [4] CLD 23 NBR 

[1] This product has also been evaluated for use in Mechanical Plumbing Device applications
    with a maximum use restriction of 0.2 square inches/L.
[2] Certified for a maximum surface area to volume ratio of 2.0 square inches/L.
[4] Certified for a maximum surface area to volume ratio of 1.1 square inches/L.
[G] Product is Certified to NSF/ANSI 372 and conforms with the lead content requirements for
    “lead free” plumbing as defined by California, Vermont, Maryland, and Louisiana state
    laws and the U.S. Safe Drinking Water Act.

Number of matching Manufacturers is 1
Number of matching Products is 5
Processing time was 0 seconds