NSF Product and Service Listings

These NSF Official Listings are current as of Saturday, August 30, 2025 at 12:15 a.m. Eastern Time. Please contact NSF to confirm the status of any Listing, report errors, or make suggestions.

Alert: NSF is concerned about fraudulent downloading and manipulation of website text. Always confirm this information by clicking on the below link for the most accurate information: http://info.nsf.org/Certified/food/Listings.asp?Standard=169&Company=C0811997&

NSF/ANSI 169
Special Purpose Food Equipment and Devices


 
ODE SRL Società Unipersonale 
Via Borgofrancone n.18
23823 Colico (LC) 
Italy 
39 03 829 301201
Visit this company's website

Facility : Guangdong Province, China


Electrovalves with Plastic Bodies[1] [Pb]
  V3(1)(2)(3)P(4)(5)[2]
  V7(1)(2)(3)P(4)(5)[2]
  
[1] (1) Two digits for the hydraulic connection.
    (2) Two digits for seal material.
    (3) Hole diamater in mm (with or without comma, ie 2, 0 or 20 is 2mm).
    (4) Five digits for special executions.
    (5) Three digits for coil code.
[2] Only acceptable for use in contact with non-carbonated potable water under constant
    service pressure, with a maximum contact temperature of 82°C.
[Pb] Product also evaluated and determined to possess weighted average lead content of
     <=0.25% and complies with lead content requirements for “lead free” plumbing as defined
     by California, Vermont, Maryland, and Louisiana state laws and the U.S. Safe Drinking
     Water Act.

Flow Meter [Pb]
  F(1)(2)(3)(4)(5)(6)(7)[3] [4]
  
[3] Approved for water contact only.
[4] (1) 2 Digit indicating body material & inlet and outlet:
        22= Plastic -- 1/4-1/4 GAS Thread
        32= SS -- 1/4-1/4 GAS Thread
        42= Brass -- 1/4-1/4 GAS Thread
        52= Plastic -- 1/8-1/8 GAS Thread
        62= SS -- 1/8-1/8 GAS Thread
        AA= SS -- 6mm-6mm Push Fit
        BB=SS -- 8mm-8mm Push Fit
        CC=Plastic -- 6mm-6mm Push Fit
        DD=Plastic -- 8mm-8mm Push Fit	
    (2) 2 Digits indicating material of pignon:
        10=plastic, 11=SS
    (3) 3 Digits indicating  diameter of orifice
    (4) 1 Digit  indicating the number of magnets
    (5) 1 Digit indicating material of cover:
        0=plastic, 1=SS
    (6) 1 Digit indicating  type of electrical connection
    (7) 1 Digit indicating type of sensor
[Pb] Product also evaluated and determined to possess weighted average lead content of
     <=0.25% and complies with lead content requirements for “lead free” plumbing as defined
     by California, Vermont, Maryland, and Louisiana state laws and the U.S. Safe Drinking
     Water Act.

Number of matching Manufacturers is 1
Number of matching Products is 3
Processing time was 0 seconds