NSF Product and Service Listings
These NSF Official Listings are current as of Friday, December 26, 2025 at 12:15 a.m. Eastern Time. Please contact NSF to confirm the status of any Listing, report errors, or make suggestions.
Alert: NSF is concerned about fraudulent downloading and manipulation of website text. Always confirm this information by clicking on the below link for the most accurate information: http://info.nsf.org/Certified/PwsComponents/Listings.asp?Company=0D680&Standard=061&
NSF/ANSI/CAN 61
Drinking Water System Components - Health Effects
Drinking Water System Components - Health Effects
NOTE: Unless otherwise indicated for Materials, Certification is only for the Water Contact Material shown in the Listing. Click here for a list of Abbreviations used in these Listings. Click here for the definitions of Water Contact Temperatures denoted in these Listings. Products certified to NSF/ANSI/CAN 61 comply with the health effects criteria in NSF/ANSI/CAN 600.
| NordiTube Technologies SE | |
| Rue Ernest Solvay 181 | |
| 4000 Liège | |
| Belgium | |
| 49 5284 94298 10 |
Facility : Liège, Belgium
Protective (Barrier) Materials
| Water | Water | |||
| Water Contact | Contact | Contact | ||
| Trade Designation | Size Restriction | Temp | Material | |
|
Coatings - Pipe - Immediate Return to Service[1] [2] |
||||
| NORDIFLOW W PE[3] [4] | >= 6" | CLD 23 | MLTPL | |
| NORDIPIPE W PE[3] [4] | >= 6" | CLD 23 | MLTPL | |
[1] Only products bearing the NSF Mark are Certified.
[2] Evaluated for Immediate Return to Service.
[3] Certified for use with r.tec 582-25 OF resin only.
[4] r. tec 582-25 OF resin is approved for the following cure parameters:
Final Cure time and temperature: Resin is mixed and applied to felt side of liner; liner
is inverted into pipe. Lined pipe is cured by hot water cure for a minimum of 5 hours at
80C. After the hot water cure, lined pipe are subject to an ambient cure of 11 days.
OR
Final Cure time and temperature: Resin is mixed and applied to felt side of liner; liner
is inverted into pipe. Lined pipe is cured by steam cure for a minimum of 3.5 hours at
80C. After the steam cure, lined pipes are subject to an ambient cure of 11 days.
|
||||
Number of matching Manufacturers is 1
Number of matching Products is 2
Processing time was 0 seconds
