NSF Product and Service Listings

These NSF Official Listings are current as of Saturday, January 22, 2022 at 12:15 a.m. Eastern Time. Please contact NSF to confirm the status of any Listing, report errors, or make suggestions.

Alert: NSF is concerned about fraudulent downloading and manipulation of website text. Always confirm this information by clicking on the below link for the most accurate information: http://info.nsf.org/Certified/PwsComponents/Listings.asp?Company=13320&Standard=061&



NSF/ANSI/CAN 61
Drinking Water System Components - Health Effects

NOTE: Unless otherwise indicated for Materials, Certification is only for the Water Contact Material shown in the Listing. Click here for a list of Abbreviations used in these Listings. Click here for the definitions of Water Contact Temperatures denoted in these Listings.


 
ITW Performance Polymers 
30 Endicott Street
Danvers, MA 01923 
United States 
978-777-1100
Visit this company's website


Facility : Danvers, MA

Joining and Sealing Materials

    Water Water
    Contact Contact
Trade Designation Size Temp Material

Patching Materials [G]
Devcon Stainless Steel Putty [1] CLD 23 SSEP

[1] Certified for use up to 10% of the surface area in tanks 60,000 gallons and greater.
[G] Product is Certified to NSF/ANSI 372 and conforms with the lead content requirements for
    “lead free” plumbing as defined by California, Vermont, Maryland, and Louisiana state
    laws and the U.S. Safe Drinking Water Act.

    


Protective (Barrier) Materials

    Water Water
  Water Contact Contact Contact
Trade Designation Size Restriction Temp Material

Coatings - Valve
Brushable Ceramic White[1] >= 4" D. HOT EPOXY

[1] Colors: White
    Number of Coats: 2
    Maximum Field Use Dry Film Thickness (in mils): 40
    Maximum Thinner: None
    Recoat Cure Time and Temperature: 4 hours at 70°F
    Final Cure Time and Temperature: 7 days at 70°F
    Special Comments: Mix ratio of A:B is 5.6:1 by volume.


Number of matching Manufacturers is 1
Number of matching Products is 2
Processing time was 0 seconds