NSF Product and Service Listings

These NSF Official Listings are current as of Friday, December 26, 2025 at 12:15 a.m. Eastern Time. Please contact NSF to confirm the status of any Listing, report errors, or make suggestions.

Alert: NSF is concerned about fraudulent downloading and manipulation of website text. Always confirm this information by clicking on the below link for the most accurate information: http://info.nsf.org/Certified/PwsComponents/Listings.asp?Company=1P870&Standard=061&


NSF/ANSI/CAN 61
Drinking Water System Components - Health Effects

NOTE: Unless otherwise indicated for Materials, Certification is only for the Water Contact Material shown in the Listing. Click here for a list of Abbreviations used in these Listings. Click here for the definitions of Water Contact Temperatures denoted in these Listings. Products certified to NSF/ANSI/CAN 61 comply with the health effects criteria in NSF/ANSI/CAN 600.

 
Specialties Construction Chemicals Factory 
Amghara Ind. Area
Area No. 2, Block: 70 
Kuwait 
965 456 5145 65
Visit this company's website


Facility : Amghara Ind. Area, Kuwait

Joining and Sealing Materials

    Water Water
    Contact Contact
Trade Designation Size Temp Material

Sealants
Kut Durathane 920 - Gun Grade -Standard Shore A White[1] [2] [3] C. HOT PUR
Kut Durathane 920 Pouring Grade White[1] [2] [3] C. HOT PUR 

[1] Final Cure Time And Temperature: 14 days at 75ºF
    Special Comments: Mix ratio of Part A:Part B is 100:7 by weight. Induction time of
    15 minutes is required. Certification does not include any primers
[2] Only products bearing the NSF Mark on the product, product packaging, and/or
    documentation shipped with the product are Certified.
[3] Restricted to a maximum surface area to volume ratio of 1% of a 30,000 gallon tank.


Protective (Barrier) Materials

    Water Water
  Water Contact Contact Contact
Trade Designation Size Restriction Temp Material

Coatings - Tank
Kut Duracoat 1000 R[1] [2] C. HOT PUR 

[1] Number of Coats: 2-4 (2-4 coats for 60 mil thickness, 3-4 coats for 160 mil thickness)
    Maximum Field Use Dry Film Thickness (in mils): 60-160
    Recoat Cure Time and Temperature: 3 hours at 25°C
    Final Cure Time and Temperature: 7 days at 25°C
    Special Comments: Mix ratio of A:B is 7:1 by weight.  Induction time of 5 minutes is
    required.
[2] Certified for 2% of a 10,000,000 gallon tank and greater or 14% of a 50,000,000 gallon
    tank and greater.

Number of matching Manufacturers is 1
Number of matching Products is 3
Processing time was 0 seconds