NSF Product and Service Listings

These NSF Official Listings are current as of Friday, December 26, 2025 at 12:15 a.m. Eastern Time. Please contact NSF to confirm the status of any Listing, report errors, or make suggestions.

Alert: NSF is concerned about fraudulent downloading and manipulation of website text. Always confirm this information by clicking on the below link for the most accurate information: http://info.nsf.org/Certified/PwsComponents/Listings.asp?Company=C0023384&Standard=061&


NSF/ANSI/CAN 61
Drinking Water System Components - Health Effects

NOTE: Unless otherwise indicated for Materials, Certification is only for the Water Contact Material shown in the Listing. Click here for a list of Abbreviations used in these Listings. Click here for the definitions of Water Contact Temperatures denoted in these Listings. Products certified to NSF/ANSI/CAN 61 comply with the health effects criteria in NSF/ANSI/CAN 600.

 
RS Technik / HammerHead 
Earth Tool Company LLC
(Hamerhead Trenchless) 
500 South C.P. Avenue 
Lake Mills, WI 53551 
United States 
920-648-4848
Visit this company's website


Facility : Lake Mills, WI

Protective (Barrier) Materials

    Water Water
  Water Contact Contact Contact
Trade Designation Size Restriction Temp Material

Pipe Liner - Immediate Return to Service
HammerHead LPA[1] [2] [3] [4] >= 6" CLD 23 EPOXY
RS BlueLine®[1] [2] [3] [4] >= 6" CLD 23 EPOXY 

[1] Certified for immediate return to service.
[2] After initial cure, pipe must be flushed with water at ambient temperature for 15
    minutes.
[3] Cure Method MaxPox 8D/480D Hot Water Cure: Resin is mixed and applied using vacuum
    saturation to the liner, then cured by a hot water cure for a minimum of 1 hour at 80°C.
    After the hot water cure, lined pipes are subject to an ambient cure for 45 hours. 
    
    Cure Method MaxPox 15D/480D Hot Water Cure: Resin is mixed and applied using vacuum
    saturation to the liner, then cured by a hot water cure for a minimum of 1 hour at 80°C.
    After the hot water cure, lined pipes are subject to an ambient cure for 48 hours. 
    
    Cure Method MaxPox 8D/480D Steam Cure: Resin is mixed and applied using vacuum
    saturation to the liner, then cured by a steam water cure for a minimum of 1 hour at
    80°C. After the steam cure, lined pipes are subject to an ambient cure for 45 hours.
    
    Cure Method LPA Part A and Part B Hot Water Cure: Resin is mixed and applied using
    vacuum saturation to the liner, then cured by a hot water cure for a minimum of 1 hour
    at 80C. After the hot water cure, lined pipes are subject to an ambient cure of 45
    hours. 
[4] Special Comments: Mix ratio of resin to hardener is 76% +/- 2% Part A & 24% +/- 2% Part
    B by weight for MaxPox 8D/480D or Max Pox 15D/480D.  Mix thoroughly for a minimum of 3
    minutes at 200 rpm.

Number of matching Manufacturers is 1
Number of matching Products is 2
Processing time was 0 seconds