NSF Product and Service Listings

These NSF Official Listings are current as of Thursday, January 20, 2022 at 12:15 a.m. Eastern Time. Please contact NSF to confirm the status of any Listing, report errors, or make suggestions.

Alert: NSF is concerned about fraudulent downloading and manipulation of website text. Always confirm this information by clicking on the below link for the most accurate information: http://info.nsf.org/Certified/PwsComponents/Listings.asp?Company=C0056155&Standard=061&



NSF/ANSI/CAN 61
Drinking Water System Components - Health Effects

NOTE: Unless otherwise indicated for Materials, Certification is only for the Water Contact Material shown in the Listing. Click here for a list of Abbreviations used in these Listings. Click here for the definitions of Water Contact Temperatures denoted in these Listings.


 
Chugoku-Boat Italy SpA 
S.S. Alessandria, 57-59
15068 Pozzolo Formigaro, Alessandria 
Italy 
39 01 43318723
Visit this company's website


Facility : Rivalta Scrivia (AL), Italy

Protective (Barrier) Materials

    Water Water
  Water Contact Contact Contact
Trade Designation Size Restriction Temp Material

Coatings - Pipe
Clean Keep 5000[1] >= 48" CLD 23 EPOXY

[1] Colors: Red brown, off-white
    Number of Coats: 1-2
    Sequence of Coats: 1 coat application: off-white; 2 coat application: red brown then
    off-white
    Maximum Field Use Dry Film Thickness (in mils): 24 (max 12 per coat)
    Recoat Cure Time and Temperature: 32 hours at 20°C
    Final Cure Time and Temperature: 7 days at 23°C
    Special Comments: Mix ratio of Part A:Part B is 88:12 by weight or 81:19 by volume.
    Curing should occur under continuous ventilation.

Coatings - Tank
Clean Keep 5000[1] >= 7000 gal. CLD 23 EPOXY

[1] Colors: Red brown, off-white
    Number of Coats: 1-2
    Sequence of Coats: 1 coat application: off-white; 2 coat application: red brown then
    off-white
    Maximum Field Use Dry Film Thickness (in mils): 24 (max 12 per coat)
    Recoat Cure Time and Temperature: 32 hours at 20°C
    Final Cure Time and Temperature: 7 days at 23°C
    Special Comments: Mix ratio of Part A:Part B is 88:12 by weight or 81:19 by volume.
    Curing should occur under continuous ventilation.

Coatings - Valve
Clean Keep 5000[1] >= 6" CLD 23 EPOXY

[1] Colors: Red brown, off-white
    Number of Coats: 1-2
    Sequence of Coats: 1 coat application: off-white; 2 coat application: red brown then
    off-white
    Maximum Field Use Dry Film Thickness (in mils): 24 (max 12 per coat)
    Recoat Cure Time and Temperature: 32 hours at 20°C
    Final Cure Time and Temperature: 7 days at 23°C
    Special Comments: Mix ratio of Part A:Part B is 88:12 by weight or 81:19 by volume.
    Curing should occur under continuous ventilation.


Number of matching Manufacturers is 1
Number of matching Products is 3
Processing time was 0 seconds