NSF Product and Service Listings
These NSF Official Listings are current as of Friday, December 26, 2025 at 12:15 a.m. Eastern Time. Please contact NSF to confirm the status of any Listing, report errors, or make suggestions.
Alert: NSF is concerned about fraudulent downloading and manipulation of website text. Always confirm this information by clicking on the below link for the most accurate information: http://info.nsf.org/Certified/PwsComponents/Listings.asp?Company=C0094336&Standard=061&
NSF/ANSI/CAN 61
Drinking Water System Components - Health Effects
Drinking Water System Components - Health Effects
NOTE: Unless otherwise indicated for Materials, Certification is only for the Water Contact Material shown in the Listing. Click here for a list of Abbreviations used in these Listings. Click here for the definitions of Water Contact Temperatures denoted in these Listings. Products certified to NSF/ANSI/CAN 61 comply with the health effects criteria in NSF/ANSI/CAN 600.
| Desarrollos Quimicos Mundiales S.A. de C.V. | |
| Libramiento Noreste 1013 | |
| Parque Ind, Mitras 66000 | |
| Mexico | |
| 52 818 381 0421 | |
| Visit this company's website |
Facility : Garcia, Mexico
Protective (Barrier) Materials
| Water | Water | |||
| Water Contact | Contact | Contact | ||
| Trade Designation | Size Restriction | Temp | Material | |
|
Coatings - Pipe[1] |
||||
| DQM 1810 A HS EPOXI HIGH SOLIDS | >= 30" | CLD 23 | EPOXY | |
| DQM A26 A HS EPOXI HIGH SOLIDS | >= 30" | CLD 23 | EPOXY | |
[1] Colors: White
Number of Coats: 1 - 2
Maximum Field Use Dry Film Thickness (in mils): 16
Maximum Thinner: None
Recoat Cure Time and Temperature: 24 - 36 hours at 25°C
Final Cure Time and Temperature: 14 days at 25°C
Special Comments: Mix ratio of Part A to Part B is 1:1 by volume. After 14 days of
curing, rinse with distilled water at a rate of 5 liters per minute for 30 minutes, then
allow to dry for 3 hours.
|
||||
Number of matching Manufacturers is 1
Number of matching Products is 2
Processing time was 0 seconds
