NSF Product and Service Listings

These NSF Official Listings are current as of Friday, December 26, 2025 at 12:15 a.m. Eastern Time. Please contact NSF to confirm the status of any Listing, report errors, or make suggestions.

Alert: NSF is concerned about fraudulent downloading and manipulation of website text. Always confirm this information by clicking on the below link for the most accurate information: http://info.nsf.org/Certified/PwsComponents/Listings.asp?Company=C0120829&Standard=061&


NSF/ANSI/CAN 61
Drinking Water System Components - Health Effects

NOTE: Unless otherwise indicated for Materials, Certification is only for the Water Contact Material shown in the Listing. Click here for a list of Abbreviations used in these Listings. Click here for the definitions of Water Contact Temperatures denoted in these Listings. Products certified to NSF/ANSI/CAN 61 comply with the health effects criteria in NSF/ANSI/CAN 600.

 
Yung Chi Paint & Varnish Mfg. Co., Ltd. 
No. 26 Yen Hai 3rd Road
Kaohsiung 
Taiwan 
886 7 871 3181


Facility : Kaohsiung, Taiwan

Protective (Barrier) Materials

    Water Water
  Water Contact Contact Contact
Trade Designation Size Restriction Temp Material

Coatings - Tank
NO.4567 LT SOLVENT FREE AMINE-CURED EPOXY FOR WATER TANK (for LOW TEMPRATURE)[1] > 5,000,000 gal. CLD 23 EPOXY
NO.4567 SOLVENT FREE AMINE-CURED EPOXY FOR WATER TANKS[2] > 750,000 gal. D. HOT EPOXY 

[1] Colors: Ivory
    Number Of Coats: 1-2
    Maximum Field Use Dry Thickness(in mils): 12 mils
    Recoat Cure Time and Temperature: 8 hours at 25°C
    Final Cure Time/Temperature: 7 days at 25°C
    Special Comments: Mix ratio of Part A:B is 3:1 by weight
[2] Colors: White
    Number of Coats: 1-2 
    Maximum Field Use Dry Film Thickness (in mils): 12
    Recoat Cure Time and Temperature: 12 hours at 25°C
    Final Cure Time and Temperature: 5 days at 25°C
    Special Comments: Mix ratio of Base:Hardner is 3:1 by weight. Mix base and hardener
    thoroughly and then apply within 60 minutes.  Apply by airless spray, preferably above
    60:1, with tip size 0.029" - 0.035" and 6 Kg/cm^2 air pressure.

Number of matching Manufacturers is 1
Number of matching Products is 2
Processing time was 0 seconds