NSF Product and Service Listings

[1] In the trade names, XX refers to gear ratio, YY refers to connection thread (where M is
    BPST and 0 is NPT), and ZZ refers pump options. S may be added as a prefix to the model
    number if the pump supplied as Control (SMART) Version. D is added as a prefix to model
    number if pump supplied as duplex version. N is a place separation between Liquid Head
    size and Liquid Head material identification.
[2] Certified for use with the following chemicals, when dosed at the typical use level
    (TUL) in Standard 60:
    Aluminum chlorohydrate (40%), aluminum sulfate (50%), ammonium hydroxide (29%),
    hydrofluorosilicic acid (30%), sodium bisulite (44%), sodium hydroxide(50%), and zinc
    orthophosphate (100%).
[3] Certified for use with the following chemicals, when dosed at the typical use level
    (TUL) in Standard 60:
    Aluminum chlorohydrate (40%), aluminum sulfate (50%), ammonium hydroxide (29%),ferric
    chloride (45%), hydrofluorosilicic acid (30%), sodium bisulfite (44%), sodium
    hypochlorite (15%), and zinc orthophosphate (100%).
[4] Certified for use with the following chemicals when dosed at the typical use level (TUL)
    in Standard 60:
    Aluminum chlorohydrate (40%), aluminum sulfate (50%), ammonium hydroxide (29%), ferric
    chloride (45%), hydrochloric acid (37%), hydrofluorosilicic acid (30%), sodium bisulfite
    (44%), sodium hypochlorite (15%), sulfuric acid (98%), and zinc orthophosphate (100%).
[G] Product is Certified to NSF/ANSI/CAN 372 and conforms with the lead content requirements
    for "lead free" plumbing as defined by California, Vermont, Maryland, and Louisiana
    state laws and the U.S. Safe Drinking Water Act.

[5] Naming Convention for 850 Pump w/ Motor:
    A/B/C/D/E/F/G/H/I/J/K
    A = Assembly type
    B =Model (850CC)
    C = Pump size
    D = Speed
    E = Impeller Trim
    F = Motor Phase (S single, T three phase)
    G = Motor Type
    H = Motor HP
    I = Motor Frame Size
    J = Motor Frame Series
    K = Powder Coated Option
    Naming Convention for 850 Pump w/o Motor:
    A/B/C/D/E/F/G
    A = Assembly type
    B =Model (850CC, 850FM)
    C = Pump size
    D = Speed
    E = Impeller Trim
    F = Power End Size
    G = Powder Coated Option
    Naming Convention for 850 Frame Mounted Pump
    A/B/C/D/E/F/G
    A = Assembly type
    B =Model (850FM)
    C = Pump size
    D = Speed
    E = Impeller Trim
    F = Power Frame Size
    G = Powder Coated Option
    Certified for the following seal material options:
    NONE = CARBON/CERAMIC/BUNAN (STANDARD)
    CSV = CARBON/SIC/VITON
[G] Product is Certified to NSF/ANSI/CAN 372 and conforms with the lead content requirements
    for "lead free" plumbing as defined by California, Vermont, Maryland, and Louisiana
    state laws and the U.S. Safe Drinking Water Act.