NSF Product and Service Listings

These NSF Official Listings are current as of Saturday, October 25, 2025 at 12:15 a.m. Eastern Time. Please contact NSF to confirm the status of any Listing, report errors, or make suggestions.

Alert: NSF is concerned about fraudulent downloading and manipulation of website text. Always confirm this information by clicking on the below link for the most accurate information: http://info.nsf.org/Certified/PwsComponents/Listings.asp?Company=C0856033&Standard=061&


NSF/ANSI/CAN 61
Drinking Water System Components - Health Effects

NOTE: Unless otherwise indicated for Materials, Certification is only for the Water Contact Material shown in the Listing. Click here for a list of Abbreviations used in these Listings. Click here for the definitions of Water Contact Temperatures denoted in these Listings. Products certified to NSF/ANSI/CAN 61 comply with the health effects criteria in NSF/ANSI/CAN 600.

 
Trenton Corporation 
7700 Jackson Road
Ann Arbor, MI 48103 
United States 
734-424-3600
Visit this company's website


Facility : Ann Arbor, MI

Protective (Barrier) Materials

    Water Water
  Water Contact Contact Contact
Trade Designation Size Restriction Temp Material

Other[1]
MCO® 110 Adhesive 0.3 sq. in./L CLD 23 MLTPL
MCO® 110 Outerwrap 0.3 sq. in./L CLD 23 MLTPL
Temcoat™ 3000 Primer [2] [3] CLD 23 MLTPL
Wax-Tape® #1 Anticorrosion Wrap[4] [2] [3] CLD 23 MLTPL
Wax-Tape® #2 Anticorrosion Wrap[5] [2] [3] CLD 23 MLTPL 

[1] Certified for the following application parameters:					
    1. Apply Temcoat 3000 Primer to maximum of 16 mils. There is no cure time.					
    2. Apply a layer of Wax Tape #1 or Wax Tape #2. There is no cure time. 					
    3. If using, apply MCO 110 Outerwrap over wax tape. Fasten the end of the MCO 110
    Outerwrap with a thin line of MCO 110 Adhesive. If					
    MCO 110 Outerwrap is used, a minimum cure time of 1 hour at 70F is required.
[2] Certified for a maximum surface area to volume ratio of 3.3 sq. in./L without MCO
    Outerwrap and MCO 110 Adhesive
[3] Certified for a maximum surface area to volume ratio of 0.3 sq. in./L when used with MCO
    Outerwrap and MCO 110 Adhesive
[4] Wax-Tape® #1 anticorrosion wrap Certified color is Brown
[5] Wax-Tape® #2 anticorrosion wrap Certified colors are Aluminum, Brown, White, Yellow,
    Red, Tan, Purple, Black, Orange, Blue and Green


NOTE: Only products bearing the NSF Mark on the product, product packaging, and/or
      documentation shipped with the product are Certified.
Number of matching Manufacturers is 1
Number of matching Products is 5
Processing time was 0 seconds