NSF Product and Service Listings

[1] Description: Range of counter-top ambient, cold or carbonated water dispensing units
    with the flow controlled via a solenoid valve activated by a push-button.
    
    Differences in models.
    C - Cold Water dispensed
    AC - Ambient & Cold water dispensed
    ACWG	Ambient + Cold + Sparkling Water (WG = With Gas) dispensed
    EC - Electronic Control (Version with display)
    UV - UV Lamp installed inside the chassis, not in contact with water.
    IN – IN = Inside, a watercooler installed inside a bench table. IN models are like the
    TOP models, but without solenoid valves for dispensing, as they are “pass-through”
    water-coolers, where the out-water is to be controlled and dispensed by external taps or
    dispensing equipment.  
    TOP - Table “Top” Watercooler
    IB - “ICE BANK” cooling technology.
    
    Msrking: Celli Spa, Model, WRAS, Serial number and other technical information on
    adhesive label on rear of unit
    
    Notes: For models without carbonated water an approved single check valve must be fitted
    upstream of the inlet hose. For models that include carbonated water an approved double
    check valve constructed from chrome nickel stainless steel must be fitted upstream of
    the inlet hose.

[2] Description:  Range of floor standing or wall mounted water dispensers with optional
    different faucet used (G61, G62, G63). Maximum working pressure 6.0 Bar Maximum
    operating temperature 24.0°C
    
    Differences in models:
    A Ambient Water dispensed 
    C Cold Water dispensed 
    IB It means “ICE BANK” cooling technology. 
    G6x Reference to the faucet used (G61, G62, G63)
    
    
    Marking: Cosmetal, Model and technical information on sticker on back of machine
    
    Notes : This tap should be installed so that its base is no lower than the spillover
    level of the sink, basin, or other receiving vessel.  If not, appropriate
    backflow protection to Fluid Category 5 must be applied.
    
    Backflow prevention protection to at least fluid category two shall be fitted at the
    point of connection(s) between the water supply and the fitting or appliance, an
    ‘Approved’ single check valve or some other no less effective backflow prevention device.